Round-nose bit burning

Shawn,

I'm going out on a limb here - and I've never tried this - but I seem to
recall someone saying that when they made some flutes they wet the wood
first (dampen, not sopping wet) on the last pass to alleviate the burning.

Now that sounds okay but never having done it, I guess I would try a few
test pieces that were clamped down real good before attempting it on any
good stock.

The more I think about it, I think I got that tip from the woodturning
group. Give it a try, if it works or not, how about telling us the results.

Bob S.


"Shawn" <[email protected]> wrote in message
news:[email protected]...
> I recently tried putting flutes in some Red Oak using a 1/2" round-nosed
> bit and got lots of burning at the ends of the flutes - no matter how
> quickly I tried to back-off from the finish or start of the flutes. The
> flutes were only about 1/4"-3/8" deep, so I did them in one pass. Sanding
> all the ends was a real PITA, so is this typical or is there a solution?
> The bit was one that hadn't been used before.
>
> TIA,
> Shawn in Moscow (Idaho that is)
> (reply in group please)

Shawn from my experience that is Typical from round nosed bits even in
softer woods
Sometimes you can alleviate it somwhat by doing a second cut and do not be
slow in starting and stopping the longer the bit is at the start and stop
positions the more burn you will get, and yes the sanding is
a real bonifide ROYAL PITA

George


"Shawn" <[email protected]> wrote in message
news:[email protected]...
> I recently tried putting flutes in some Red Oak using a 1/2" round-nosed
> bit and got lots of burning at the ends of the flutes - no matter how
> quickly I tried to back-off from the finish or start of the flutes. The
> flutes were only about 1/4"-3/8" deep, so I did them in one pass. Sanding
> all the ends was a real PITA, so is this typical or is there a solution?
> The bit was one that hadn't been used before.
>
> TIA,
> Shawn in Moscow (Idaho that is)
> (reply in group please)