Hi Y'all
On the cover of Fine Woodworking April 2004 shows a man doing some resawing
on a bandsaw utilising a [gravity powered] feeder. Unfortunately, this issue
didn't cover the feeder. The article was actually about bandsaw blades. Has
there been an article (in this mag or another) covering the feeder?
TIA
Joe
The writer only made that fixture to test bandsaw blades. He was not to
concerend with make a project, just testing speed and the quality of the
cut.
Dave
"Joe_Stein" <[email protected]> wrote in message
news:[email protected]...
> Hi Y'all
> On the cover of Fine Woodworking April 2004 shows a man doing some
resawing
> on a bandsaw utilising a [gravity powered] feeder. Unfortunately, this
issue
> didn't cover the feeder. The article was actually about bandsaw blades.
Has
> there been an article (in this mag or another) covering the feeder?
> TIA
> Joe
>
>
Posted Via Usenet.com Premium Usenet Newsgroup Services
----------------------------------------------------------
** SPEED ** RETENTION ** COMPLETION ** ANONYMITY **
----------------------------------------------------------
http://www.usenet.com
----== Posted via Newsfeed.Com - Unlimited-Uncensored-Secure Usenet News==----
http://www.newsfeed.com The #1 Newsgroup Service in the World! >100,000 Newsgroups
---= 19 East/West-Coast Specialized Servers - Total Privacy via Encryption =---
"Joe_Stein" <[email protected]> wrote in message
news:[email protected]...
>
> On the cover of Fine Woodworking April 2004 shows a man doing some
resawing
> on a bandsaw utilising a [gravity powered] feeder. Unfortunately, this
issue
I saw that too and NTMK, it hasn't been covered. Looked pretty
straightforward - full extension drawer slide, pully, rope. Couldn't figure
out a good way to attach the stock to the jig without screwing it in.
I have never seen a home make device of this type but have seen a number of
industrial bandsaws with gravity feeders. The table moves.
"Joe_Stein" <[email protected]> wrote in message
news:[email protected]...
> Hi Y'all
> On the cover of Fine Woodworking April 2004 shows a man doing some
resawing
> on a bandsaw utilising a [gravity powered] feeder. Unfortunately, this
issue
> didn't cover the feeder. The article was actually about bandsaw blades.
Has
> there been an article (in this mag or another) covering the feeder?
> TIA
> Joe
>
>