FS Lathe - Kent, Washington USA

canadian or american
in article [email protected], Gunner York at
[email protected] wrote on 2/29/04 7:28 PM:

> This lathe was made by F. E. Wells and Son of Greenfield, Mass. It is older
> but a solid piece of equipment. 24" between centers x 5" Swing over bed (10"
> diameter stock). Has a 220 three phase motor with mag switch, tool rest, and
> tapered tail stock. The bed and legs are cast iron. No chuck or other
> tooling available.
>
> I was going to tool this lathe up, but found a deal on a complete lathe with
> accessories and tooling.
>
> $250.00
>
> Picture available upon request. Viewing by appointment only. You must pick
> up in Kent, Washington USA. I will not ship.
>
> [email protected]
> Remove REMOVETHIS to reply.
>
>

nevermind

> canadian or american
> in article [email protected], Gunner York at
> [email protected] wrote on 2/29/04 7:28 PM:
>
>> This lathe was made by F. E. Wells and Son of Greenfield, Mass. It is older
>> but a solid piece of equipment. 24" between centers x 5" Swing over bed (10"
>> diameter stock). Has a 220 three phase motor with mag switch, tool rest, and
>> tapered tail stock. The bed and legs are cast iron. No chuck or other
>> tooling available.
>>
>> I was going to tool this lathe up, but found a deal on a complete lathe with
>> accessories and tooling.
>>
>> $250.00
>>
>> Picture available upon request. Viewing by appointment only. You must pick
>> up in Kent, Washington USA. I will not ship.
>>
>> [email protected]
>> Remove REMOVETHIS to reply.
>>
>>
>