Saw Duginske do something I had started to wonder about when I was
jointing some rough, cupped stock.
I had started to wonder why I was face jointing the stock completely
flat. Wondered if I was able to establish flat spots on both sides,
the complete length of the board, if a couple of light passes on the
planer would help.
http://www.taunton.com/store/pages/061011.asp
I'm going to finish my personal experiment with this tonight - having
jointed a couple of white oak and maple test pieces.
I'd suspect you'd have to take light passes on the planer as to not
compress the stock.
On Tue, 05 Oct 2004 17:07:25 GMT, patrick conroy
<[email protected]> wrote:
>Saw Duginske do something I had started to wonder about when I was
>jointing some rough, cupped stock.
>
>I had started to wonder why I was face jointing the stock completely
>flat. Wondered if I was able to establish flat spots on both sides,
>the complete length of the board, if a couple of light passes on the
>planer would help.
>
>http://www.taunton.com/store/pages/061011.asp
>
>I'm going to finish my personal experiment with this tonight - having
>jointed a couple of white oak and maple test pieces.
>
>I'd suspect you'd have to take light passes on the planer as to not
>compress the stock.
as long as you have enough of the cupped face flat that it'll
besupported in the planer you'll be fine. the actual percentage needed
will vary with species, moisture content, width and thickness. it's a
judgement call.