OK, I couldn't resist it. Picked up an old belt-drive jointer (Sprunger
4.5") at a recent estate sale.
So now I need a couple of pieces of information:
1) What's the recommended RPM on this thing?
2) There was no fence; Where's a good place to look for a replacement
fence, or should I just build my own?
In article <[email protected]>,
"Bob" <[email protected]> wrote:
> Check here http://www.owwm.com/PhotoIndex/detail.asp?id=175 and snoop
> around.
OK, I probably should have said I'd already been there. It showed me
photos of what the fence shgould look like, but other than that was of
limited use.
It gave me the idea of looking for a powr-kraft jointer fence, but
beyond that didn't offer much help.
Is the an aftermarket fence that might work?
> Bob S.
>
>
> "Arlen Walker" <[email protected]> wrote in message
> news:[email protected]...
> > OK, I couldn't resist it. Picked up an old belt-drive jointer (Sprunger
> > 4.5") at a recent estate sale.
> >
> > So now I need a couple of pieces of information:
> >
> > 1) What's the recommended RPM on this thing?
> >
> > 2) There was no fence; Where's a good place to look for a replacement
> > fence, or should I just build my own?
Check here http://www.owwm.com/PhotoIndex/detail.asp?id=175 and snoop
around.
Bob S.
"Arlen Walker" <[email protected]> wrote in message
news:[email protected]...
> OK, I couldn't resist it. Picked up an old belt-drive jointer (Sprunger
> 4.5") at a recent estate sale.
>
> So now I need a couple of pieces of information:
>
> 1) What's the recommended RPM on this thing?
>
> 2) There was no fence; Where's a good place to look for a replacement
> fence, or should I just build my own?