I posted this yesterday but it did not show up on the NG so I'll try again.
I'm preparing to build a tember frame home and I'll have to do a lot of
tounge and groove. I've been looking for a used single phase spindle
moulder but I may have to buy new. It will only get used for this one job
but it's a big job. So what to buy?? Also where can I buy cutters to do
T&G.
TIA
Thanks for the info. I'm considering the G1026 spindle shaper. At just
over $1000 delivered it looks like my best bet. Hopefully it will do the
job.
"John Grossbohlin" <[email protected]> wrote in message
news:[email protected]...
>
> "Greg Neill" <[email protected]> wrote in message
> news:[email protected]...
>> "Sail-n-Dive" <[email protected]> wrote in message
>> news:[email protected]...
>>> I posted this yesterday but it did not show up on the NG so I'll try
>>> again.
>>>
>>> I'm preparing to build a tember frame home and I'll have to do a lot of
>>> tounge and groove. I've been looking for a used single phase spindle
>>> moulder but I may have to buy new. It will only get used for this one
>>> job
>>> but it's a big job. So what to buy?? Also where can I buy cutters to
>>> do
>>> T&G.
>>
>> http://www.grizzly.com/products/category.aspx?key=161410
>>
>
> For a shaper he'd need cutters...
>
> http://www.grizzly.com/products/searchresults.aspx?q=tongue+and+groove+cutter&submit.x=5&submit.y=7
>
>
>
"Greg Neill" <[email protected]> wrote in message
news:[email protected]...
> "Sail-n-Dive" <[email protected]> wrote in message
> news:[email protected]...
>> I posted this yesterday but it did not show up on the NG so I'll try
>> again.
>>
>> I'm preparing to build a tember frame home and I'll have to do a lot of
>> tounge and groove. I've been looking for a used single phase spindle
>> moulder but I may have to buy new. It will only get used for this one
>> job
>> but it's a big job. So what to buy?? Also where can I buy cutters to do
>> T&G.
>
> http://www.grizzly.com/products/category.aspx?key=161410
>
For a shaper he'd need cutters...
http://www.grizzly.com/products/searchresults.aspx?q=tongue+and+groove+cutter&submit.x=5&submit.y=7
"Sail-n-Dive" <[email protected]> wrote in message news:[email protected]...
> I posted this yesterday but it did not show up on the NG so I'll try again.
>
> I'm preparing to build a tember frame home and I'll have to do a lot of
> tounge and groove. I've been looking for a used single phase spindle
> moulder but I may have to buy new. It will only get used for this one job
> but it's a big job. So what to buy?? Also where can I buy cutters to do
> T&G.
http://www.grizzly.com/products/category.aspx?key=161410