Yes, make sure the new motor turns in the same directions as your old
one. Make sure the continues rating is the same as your old one. Make
sure the RPM on the old matches the new one. Make sure the frames are
identical or will you need an adapter. Make sure the old pulley can be
moved to the new one or buy a new one at Tractor Supply while you are
there. Do you need a new belt as well? See if TS has one of those as well.
Mike in Ohio
On 02/06/2011 05:18 PM, [email protected] wrote:
> Thanks for the leads, guys. I'm going to take a look at a 2hp, 3450 RPM
> motor for $139 from Tractor Supply. I'll take the old motor with me to
> compare spindle and pulley sizes. Any "gotchas"? TS labels this as a
> compressor motor.
On Sun, 06 Feb 2011 21:38:33 -0600, Martin Eastburn
<[email protected]> wrote:
>Make sure it is continuous duty motor. you won't want to cool it off
>for three out of four hours or anything like that...
>
>Continuous run 24/7 without overheating.
>
>Martin
>
>
>On 2/6/2011 4:18 PM, [email protected] wrote:
>> Thanks for the leads, guys. I'm going to take a look at a 2hp, 3450 RPM
>> motor for $139 from Tractor Supply. I'll take the old motor with me to
>> compare spindle and pulley sizes. Any "gotchas"? TS labels this as a
>> compressor motor.
GENERALLY speaking, compressor motors are not continuous duty and are
designed for high starting torque. You do not need the high starting
torque, and jointer service is not 100% duty cycle under load - so you
might be OK.
I really like sealed (dust proof) motors for woodworking equipment
(TEFC)
Make sure it is continuous duty motor. you won't want to cool it off
for three out of four hours or anything like that...
Continuous run 24/7 without overheating.
Martin
On 2/6/2011 4:18 PM, [email protected] wrote:
> Thanks for the leads, guys. I'm going to take a look at a 2hp, 3450 RPM
> motor for $139 from Tractor Supply. I'll take the old motor with me to
> compare spindle and pulley sizes. Any "gotchas"? TS labels this as a
> compressor motor.