Hey all: I just picked up a Powr-Kraft scroll saw at an action for one
dollar, (yahoo). The numbers on it are 05FD2355 D00. It has a 4"
pulley on the right side and no motor. Any advice on what rpm this
should run at, or HP recommendations might be for the motor? It's iron
and about 30 pounds, 20" deep and 18" high. Cute little sucker.
Thank you.
On 5/11/2016 8:44 PM, kenny wrote:
> replying to Billy, kenny wrote:
> My brother was cleaning out his garage and gave me the same saw.
> What size blade fits it please?
>
You should be able to tell from looking at it whether it needs pinned or
plain ended blades. My bet is that it's using pinned, so start with a
small packet of those in 5" length. If that doesn't work - length, that
is - go to a 4" if you can find it one. My money is on a 5" pinned
blade so I'd recommend starting there.
After pinned/unpinned is determined the only other decision will be
tooth count, etc.
kenny <[email protected]> wrote:
>replying to Billy, kenny wrote:
>My brother was cleaning out his garage and gave me the same saw.
>What size blade fits it please?
http://vintagemachinery.org/photoindex/detail.aspx?id=12739
http://www.owwm.org/viewforum.php?f=1&sid=a092aa7b66c7f1d06318e99dd12104d1