"john moorhead" <[email protected]> wrote in message
news:7aawb.288126$Fm2.300849@attbi_s04...
> Folks -
>
> OK, I'll bite... I checked Oneida's site and dint see anything..... Where
> can you design a DC system online? I am needing to plumb my 2hp penn
state
> and I'd like more info...
>
> TIA
>
> John Moorhead
>
Running a 2 Hp Griz with 4 in thin wall PVC that over the years readdly
needs to be completely redone because I keep adding machines etc...and have
way too many restrictive turns etc...
Anyway I smoke (gota quit I know) and I can not tell you how many packs
(some full some not) that have been completely sucked into my system because
I sat the pack down on my drill press table then turned on the DC forgetting
the DP had the blast gate opened...
The distance between the DP and the DC is about 30 foot... and I have been
using a garbage can seperator...so Honestly my system DOES SUCK.... This
winter I wan going to redo the entitre thing..moving the DC outside in
its own little closet (more room inside the shop that way) and was going to
move up to 6 inch main lines ...maybe I am wrong but since mine SUCKS so
well I was thinking I could give up some suction for increased air flow with
6 in lines...
Bob Griffiths