Here are what I hope to be the final drawings of my new infill body.
It is 9 long and 2.5 tall at the top. This drawing is for a 2
ironed plane but I will have one for a 2.5 too. The pics show bedding
angles of 45,47,50,55 and 60. The sides are 3/16 brass and the sole
¼ steel.
Let em know if I goofed on the dovetails. They were a bit of a pain to
get the mouth where I wanted it (about 1/3 back). I liked the mouth in
them idle but it caused problems with holding the plane on my other
infills.
http://www.knight-toolworks.com/web_temp_pics/infillf.jpg
http://www.knight-toolworks.com/web_temp_pics/infillb.jpg
http://www.knight-toolworks.com/web_temp_pics/infillp.jpg
On 17 May 2006 09:37:50 -0700, [email protected] wrote:
>your drawing shows the dovetails undercut. did you do that
>intentionally, perhaps to leave room for peening or something?
right but it may be more then normal. not sure yet.