Fri, Sep 28, 2007, 10:17pm (EDT-3) [email protected] doth sayeth:
from one of the mid size delta power feeders, I'd guess. pretty stout
little mechanism.... could be a nice start on a small overarm drill
press or something.....
Overarm router?.
JOAT
What is life without challenge and a constant stream of new
humiliations?
- Peter Egan
On Sat, 29 Sep 2007 16:14:57 -0400, [email protected] (J T) wrote:
>Fri, Sep 28, 2007, 10:17pm (EDT-3) [email protected] doth sayeth:
>from one of the mid size delta power feeders, I'd guess. pretty stout
>little mechanism.... could be a nice start on a small overarm drill
>press or something.....
>
> Overarm router?.
>
>
>
>JOAT
>What is life without challenge and a constant stream of new
>humiliations?
>- Peter Egan
Very good idea..
I use the ol' shopsmith for routing once in a while just for that ability..
Though I feel "safer" with the router table and spinning bit under the work, for
some jobs it's nice to see what you're routing..
Overhead routing really sucks if you're doing drawer face rounding and the stock
isn't uniform thickness, though.. DAMHIKT
mac
Please remove splinters before emailing
On Fri, 28 Sep 2007 22:17:29 -0700, [email protected] wrote:
>from one of the mid size delta power feeders, I'd guess. pretty stout
>little mechanism.... could be a nice start on a small overarm drill
>press or something.....
maybe post a picture on ABPW?
Sounds like the kind of thing most of us like to do, so you might get some
really great ideas..
mac
Please remove splinters before emailing