I would appreciate any advice on adjusting the thickness table. The gear
underneath the worm screw where the handle attaches became loose, and the
table would not raise or lower. I was able to press the gear back in place,
but found that stock passed through the planer was out of square.
Naturally, I disocvered that Inca went out of business three years ago.
Thanks in advance for any assistace.
Michael Goldin
[email protected]
[email protected] wrote:
> I would appreciate any advice on adjusting the thickness table. The gear
> underneath the worm screw where the handle attaches became loose, and the
> table would not raise or lower. I was able to press the gear back in place,
> but found that stock passed through the planer was out of square.
> Naturally, I disocvered that Inca went out of business three years ago.
>
> Thanks in advance for any assistace.
>
> Michael Goldin
> [email protected]
>
>
There's an Inca-specific group on groups.yahoo.com - someone there might
be able to help if you don't get any good suggestions here.