[email protected] (in
[email protected]) said:
| i have a jet 14" lathe with cast iron legs. i mounted the legs in
| 8" of concrete and it vibrates when hollowing out bowls. any
| comments?
(not a lathe guy)
If it only vibrates when you're turning bowls, I'd check the spindle
bearings.
--
Morris Dovey
DeSoto Solar
DeSoto, Iowa USA
http://www.iedu.com/DeSoto
[email protected] wrote:
> i have a jet 14" lathe with cast iron legs. i mounted the legs in 8"
> of concrete and it vibrates when hollowing out bowls. any comments?
Sounds like a lot of overkill on the mounting. There are many things on a
lathe that can cause vibration to be excessive; too many to go into here.
Try googling; lots of good articles on the subject.
There will always be -some- vibration; it's a matter of how much is
reasonable. Research it for best results.
Pop