Grant wrote:
> Hello,
> Looking for a suggestion for cutting mostly 3/8 to 5/8 ply and mdf.
> Cutting VERY slight radius of only about 1.25" off the centerline
> over a 30" span. What blade for this type of cutting? Need 93.5"
> blade for my 28-299 Delta. Thanks!
Grant,
You've asked twice before and got recommendations. If you did not like what
you heard then, it will be no better now.
--
Ed
[email protected]
http://pages.cthome.net/edhome
"Grant" <[email protected]> wrote in message news:ununc.12686$A27.7259@fed1read06...
> Hello,
> Looking for a suggestion for cutting mostly 3/8 to 5/8 ply and mdf.
Cutting
> VERY slight radius of only about 1.25" off the centerline over a 30" span.
> What blade for this type of cutting? Need 93.5" blade for my 28-299
Delta.
> Thanks!
IIRC You'll get the straightest cut with the widest blade. Even a 3/4"
or 1" blade should be able to handle that curve. I'd use a fine tooth blade
on plywood.
Norm
Ed,
I asked once before and I was not specific in what I was wanting to cut. I
just asked for the most typical blades most would get for a 14" bandsaw.
Now I am being more specific.
"Edwin Pawlowski" <[email protected]> wrote in message > Grant,
> You've asked twice before and got recommendations. If you did not like
what
> you heard then, it will be no better now.
> Ed
> [email protected]
> http://pages.cthome.net/edhome
Ignore the post below. I was in dumbass mode.
"CW" <[email protected]> wrote in message
news:[email protected]...
> A 93.5 inch blade? What kind of horsepower drives it?
> "Grant" <[email protected]> wrote in message news:ununc.12686$A27.7259@fed1read06...
> > Hello,
> > Looking for a suggestion for cutting mostly 3/8 to 5/8 ply and mdf.
> Cutting
> > VERY slight radius of only about 1.25" off the centerline over a 30"
span.
> > What blade for this type of cutting? Need 93.5" blade for my 28-299
> Delta.
> > Thanks!
> >
> >
>
>
A 93.5 inch blade? What kind of horsepower drives it?
"Grant" <[email protected]> wrote in message news:ununc.12686$A27.7259@fed1read06...
> Hello,
> Looking for a suggestion for cutting mostly 3/8 to 5/8 ply and mdf.
Cutting
> VERY slight radius of only about 1.25" off the centerline over a 30" span.
> What blade for this type of cutting? Need 93.5" blade for my 28-299
Delta.
> Thanks!
>
>