Evening All,
Last Tuesday I started these six doors, today I managed to get back at them
and finish making them.
- All the parts rough cut
http://www.federatedtool.com/david/img/rsparts.jpg
- Face jointing
http://www.federatedtool.com/david/img/facejointing.jpg
- Clamping the rail and stile boards together and batch edge sanding them to
remove some tearout from the jointer
http://www.federatedtool.com/david/img/edgesanding.jpg
- Making the cope cuts in the ends of the rails
http://www.federatedtool.com/david/img/copecut.jpg
- All the parts milled up
http://www.federatedtool.com/david/img/milledparts.jpg
- The doors in clamps
http://www.federatedtool.com/david/img/clampeddoors.jpg
- Sanding the doors
http://www.federatedtool.com/david/img/sandingdoors.jpg
- Finished doors
http://www.federatedtool.com/david/img/donedoors.jpg
You can also see the face frames I am working on for the kitchen cabinets as
well. The reason the stiles are not the same width on each side is because
these are cabinet end panels and not really doors, they do look correct once
installed.
Thanks,
David.
Every neighbourhood has one, in mine, I'm him.
Remove the "splinter" from my email address to email me.
Newbies, please read this newsgroups FAQ.
rec.ww FAQ http://www.robson.org/woodfaq/
Archives http://groups.google.com/advanced_group_search
Crowbar FAQ http://www.klownhammer.org/crowbar
I was pleased to find the usual gratuitous gloat, good to see you back in
form David; you're the Where's Wally of rec.norm!
--
Greg
"David F. Eisan" wrote in message ...
> Evening All,
<snip>
> http://www.federatedtool.com/david/img/rsparts.jpg
> http://www.federatedtool.com/david/img/facejointing.jpg
> http://www.federatedtool.com/david/img/edgesanding.jpg
> http://www.federatedtool.com/david/img/copecut.jpg
> http://www.federatedtool.com/david/img/milledparts.jpg
> http://www.federatedtool.com/david/img/clampeddoors.jpg
> http://www.federatedtool.com/david/img/sandingdoors.jpg
> http://www.federatedtool.com/david/img/donedoors.jpg
>
<etc>
"David F. Eisan" <[email protected]> wrote in message news:<[email protected]>...
> Evening All,
>
> [snippety doo dah]
>
> - Finished doors
>
> http://www.federatedtool.com/david/img/donedoors.jpg
Good work, David. Especially with the handtool driveby.
Chuck Vance
"David F. Eisan" <[email protected]> wrote in
news:[email protected]:
> Chuck,
>
>> > - Finished doors
>> >
>> > http://www.federatedtool.com/david/img/donedoors.jpg
>
>> Good work, David. Especially with the handtool driveby.
>
> A little LN #3 fits in my hands very nicly....
>
> David.
>
Truth be told, almost ANYTHING LN makes fits nicely. ;-)
Patriarch,
whose anxiously awaited LN chisels "will get there when they are ready, not
before."