Snip
> As for glue, use anything other than the contact cement
> recommnded elsewhere in this thread. The traditional one is hide glue.
> Yellow glue works okay, and resorcinol glue is better.
>
> -- Andy Barss
As an aside, why not use contact cement? Admittedly, I've only used it
once, but it worked pretty well for me the one time. Is it a personal
preference, or does contact cement not perform as well under certain
circumstances?
Just curious.
-Phil Crow
If you veneer one side, you need to veneer the other side also with the same
wood or one with similar movement characteristics or the board will tend to
warp.
Preston
"pete" <[email protected]> wrote in message
news:[email protected]...
> Hi
>
> Just wanted to know whether you can apply veneer over solid hardwood,
> such as maple veneer over butternut. If so what type of adhesive would
> be the best. I will be using a shellac sealer and lacquer finish
>
> Thanks in advance
>
> Peter
>
pete wrote:
> Hi
>
> Just wanted to know whether you can apply veneer over solid hardwood,
> such as maple veneer over butternut.
Should be OK as long as the grain of both goes in the same direction.
____________
> If so what type of adhesive would
> be the best. I will be using a shellac sealer and lacquer finish
How big? If big, contact cement works. If smaller - small enough to
clamp - any woodworking glue...hide, yellow, urea formaldehyde...
--
dadiOH
____________________________
dadiOH's dandies v3.06...
...a help file of info about MP3s, recording from
LP/cassette and tips & tricks on this and that.
Get it at http://mysite.verizon.net/xico
In article <[email protected]>,
[email protected] says...
> Hi
>
> Just wanted to know whether you can apply veneer over solid hardwood,
> such as maple veneer over butternut. If so what type of adhesive would
> be the best. I will be using a shellac sealer and lacquer finish
>
> Thanks in advance
>
> Peter
>
It is recommended practice to veneer both sides, to deal with the problem Leon
touches on. As for glue, how traditional do you want to get? Hide glue <g> but
pva will work fine. Don't get the veneer too wet or it will buckle. Need to
work out a way of applying pressure over the whole work area.
-P.
--
=========================================
firstname dot lastname at gmail fullstop com
pete <[email protected]> wrote:
: Hi
: Just wanted to know whether you can apply veneer over solid hardwood,
: such as maple veneer over butternut. If so what type of adhesive would
: be the best. I will be using a shellac sealer and lacquer finish
You can -- this is how all veneered work was done prior to
the development of manmade sheetgoods
in the early 20th century, but... why would you want to?
MDF and plywood are cheaper, more stable, and flatter, than
butternut or any other solid wood.
As for glue, use anything other than the contact cement
recommnded elsewhere in this thread. The traditional one is hide glue.
Yellow glue works okay, and resorcinol glue is better.
-- Andy Barss
"pete" <[email protected]> wrote in message
news:[email protected]...
> Hi
>
> Just wanted to know whether you can apply veneer over solid hardwood,
> such as maple veneer over butternut. If so what type of adhesive would
> be the best. I will be using a shellac sealer and lacquer finish
Be certain to completely seal the wood bottom and edges. If the bottom
board expands at a different rate than the veneere.......