How to remove pressure switch cover?

I'm guessing you checked for holes that might hide set screws and/or tried
pulling the knob hard straight off in case it's a press fit.. Sorry, no
knowledge of your particular equipment.

Just pull it. If it broke, it needed replacement anyway. I would look at
the housing before pulling the button. Check especially for some sort of
holes which might indicate that the whole housing must be removed.

If the housing is loose after the screw is removed, just pulling the button
is probably the right way to go.

Michael
"evernever" <[email protected]> wrote in message
news:[email protected]...
> The picture of the switch is attached for your reference.
>
> Thanks in advance.
>
> Cheers,
> Dennis.
>
> "evernever" <[email protected]> wrote in message
> news:[email protected]...
> > I have an air compressor has a pressure switch with a pull/push round
knob
> > for power on/off. I removed the screw but this round knob is blocking
the
> > cover so I need to remove it before I can take off the cover.
> >
> > Anyone knows how to remove this knob, which can be turned round and
round,
> > so it is not screwed on.
> >
> > Please help.
> >
> > Thanks,
> > Dennis.
> >
> >
>
>
>

"evernever" <[email protected]> wrote in message
news:[email protected]...
>
> > Anyone knows how to remove this knob, which can be turned round and
round,
> > so it is not screwed on.

If it turns really easily, it sounds like it's riding on some type of spring
clip. When you look under the lower edge anywhere all the way around, is
there a hole or space anywhere? If so, then you can probably slide something
thin like a paper clip point up there to release it.

Hi All... Thanks everybody who tried to help.

I apologize that it was my mistake of not checking carefully the cover,
which was binding at the bottom but not by the round knob. I tapped the
cover few times; it came loose and I have it removed.

Thanks very much again.

Cheers,
Dennis.

"evernever" <[email protected]> wrote in message
news:[email protected]...
> The picture of the switch is attached for your reference.
>
> Thanks in advance.
>
> Cheers,
> Dennis.
>
> "evernever" <[email protected]> wrote in message
> news:[email protected]...
> > I have an air compressor has a pressure switch with a pull/push round
knob
> > for power on/off. I removed the screw but this round knob is blocking
the
> > cover so I need to remove it before I can take off the cover.
> >
> > Anyone knows how to remove this knob, which can be turned round and
round,
> > so it is not screwed on.
> >
> > Please help.
> >
> > Thanks,
> > Dennis.
> >
> >
>
>
>