When I set my Makita LS1013 SCM there is a little play when the saw is
placed in a positive stop such as a right angle cut before securing it
by tightening the long knob at the front. In other words, for a 90
degree cut, it can be right on the first time, I loosen the knob and can
push it slightly one way or the other, tighten it again and it is no
longer a right angle. I can not find anything in the manual for
adjusting this and I don't know if this is a new problem or has always
been the case. Do others have this problem and can it be fixed?
With thanks,
Glen Duff