Laser Engraving?

You can also try the local trophy and traditional engraving shops.
Most don't have a laser but they may know of a local (or semi-local)
source. A local university bookstore also subs this out. They offer
it to duplicate diploma's on wood but you can have anything done.
Charge is usually by the square inch.

Daryl

"Paul C. Proffitt" <[email protected]> wrote in message news:<[email protected]>...
> The following are two member of the Gwinnett Woodworkers Association in
> Georgia (yes, I'm a proud member, but I only wish I had a laser):
>
> Dave Spotts - HJ Products, Stone Mountain, Georgia 30087
> 770.979.4943, 770.978.6670 (fax)
>
> Victor Jones and Jim Gladstone - Atlanta Laser Works, Acworth, GA 30102
> 678.494.9692, 404.512.6998 (cell)
>
> If you decide to call either of them you might mention my name. That way
> they'll know who to blame. :-) I have no connection to either of them
> except that we belong to the same woodworking association and these are
> some good guys to work with.
>
> Paul Proffitt
>
> Rob V wrote:
> > Anyone here know of a good source of laser Engraving?
> >
> > I have a disk of Maple 3" in diameter that Id like to have some things
> > engraved on.
> >
> > Thanks
> > Rob
> >
> > You can reply to me at
> > r_b_v at v_e_r_z_e_r_a doht c_o_m
> >
> > remove _ to get the correct address
> >
> >
> > Thanks
> > Rob
> >
> > You can reply to me at
> > r_b_v at v_e_r_z_e_r_a doht c_o_m
> >
> > remove _ to get the correct address
> >
> >
> >
> >
> >

The following are two member of the Gwinnett Woodworkers Association in
Georgia (yes, I'm a proud member, but I only wish I had a laser):

Dave Spotts - HJ Products, Stone Mountain, Georgia 30087
770.979.4943, 770.978.6670 (fax)

Victor Jones and Jim Gladstone - Atlanta Laser Works, Acworth, GA 30102
678.494.9692, 404.512.6998 (cell)

If you decide to call either of them you might mention my name. That way
they'll know who to blame. :-) I have no connection to either of them
except that we belong to the same woodworking association and these are
some good guys to work with.

Paul Proffitt

Rob V wrote:
> Anyone here know of a good source of laser Engraving?
>
> I have a disk of Maple 3" in diameter that Id like to have some things
> engraved on.
>
> Thanks
> Rob
>
> You can reply to me at
> r_b_v at v_e_r_z_e_r_a doht c_o_m
>
> remove _ to get the correct address
>
>
> Thanks
> Rob
>
> You can reply to me at
> r_b_v at v_e_r_z_e_r_a doht c_o_m
>
> remove _ to get the correct address
>
>
>
>
>