On Wed, 4 Feb 2004 14:12:27 -0500, "Just Dave" <[email protected]>
wrote:
>I have the Grizzly 1023SLX and I'm looking for an after market outfeed
>table.
>
>Has anyone tried either the HTC outfeed rollers or the Delta Unisaw outfeed
>table on the Grizzlys?
>
>If so, what is your view of them?
>
>Thanks,
>Dave
>
====================================
.WHY BUY when you can custom make an outfeed table...for a few
bucks...
Like Barry I prefer a solid outfeed table over rollers ONLY because I
DO use it as an assembly table .... AND if you are worried about space
hinges are cheap so you can fold it down when not in use...
Bob Griffiths
On Wed, 4 Feb 2004 14:12:27 -0500, "Just Dave" <[email protected]>
wrote:
>I have the Grizzly 1023SLX and I'm looking for an after market outfeed
>table.
You can easily build something like this for less than $85, out of
tubafours, MDF, Formica, and some scrap hardwood:
<http://www.bburke.com/wood/images/outfeed.jpg>
The store bought rollers work OK, but a stand alone table can double
as an assembly table, complete with storage on shelves below.
Barry