I have a Jet 10" contractor TS with the Incra TS3a fence. Does anyone
have some good ideas for an outfeed table?
I know I can get a hardware kit at Woodpecker's that mounts a board to
the rail for $24.00, so I could use some mdf, but ideally, I would
like it to fold down on hinges and stand on some legs when up.
Any ideas?
Thanks,
Joe
"Joe Blow" <[email protected]> wrote in message
news:[email protected]...
>
> I have a Jet 10" contractor TS with the Incra TS3a fence. Does anyone
> have some good ideas for an outfeed table?
>
> I know I can get a hardware kit at Woodpecker's that mounts a board to
> the rail for $24.00, so I could use some mdf, but ideally, I would
> like it to fold down on hinges and stand on some legs when up.
>
> Any ideas?
>
> Thanks,
> Joe
I have the folding model of the Delta outfeed table on my saw. It is not
very complicated, and I would be happy to take some photos and send them if
you like.
Bob McBreen - Yarrow Point Washington
http://www.rockler.com/findit.cfm?page=5719
Doesn't fold though. It comes off easily. I am not sure how much space you
would really save folding one over the rear mounted motor anyway.
Bob by Chicago
"Joe Blow" <[email protected]> wrote in message
news:[email protected]...
>
> I have a Jet 10" contractor TS with the Incra TS3a fence. Does anyone
> have some good ideas for an outfeed table?
>
> I know I can get a hardware kit at Woodpecker's that mounts a board to
> the rail for $24.00, so I could use some mdf, but ideally, I would
> like it to fold down on hinges and stand on some legs when up.
>
> Any ideas?
>
> Thanks,
> Joe