Bingo. They cost, what, $7 a bottle? Buy one of each and as you start
using them you'll see that the #20s get used most of the time, but you'll
have the others for when you need them.
--
Larry C in Auburn, WA
"Unisaw A100" <[email protected]> wrote in message
news:[email protected]...
> Keith Boeheim wrote:
> >I got a dewalt biscuit joiner for christmas and I would like to know
which
> >applications would use the #0, #10 and #20 biscuits? Is there a universal
> >size tat would be for most applications?
>
>
> Areas/items requiring the #0 take a number #0.
>
> Same goes for #10 and #20.
>
> OK, all kidding aside, OK, actually that was an answer, I
> find that most (all) of the time I use the #20. When a #20
> won't fit I use a #10 and when a #10 won't do I use the #0.
> And when the #0 won't do I use the #FF (I have a
> Porter-Capable).
>
> Let's put it this way. A bottle each of the #0 and #10 will
> last as long as ten packs/containers/bottles of the #20.
>
> Your Mileage May Vary.
>
> UA100
Also, in circumstances like face frames, the biscuit can stick out a bit,
then cut off after glue-up. This only works if the biscuit going to be
hidden, trimmed over, or it doesn't matter.
HTH,
Jeffo
"Frank McVey" <[email protected]> wrote in message
news:[email protected]...
> No. Use the largest size you can get away with. They're not that
> expensive, so lay in a range.
>
> Cheers
>
> Frank
>
>
> "Keith Boeheim" <[email protected]> wrote in message
> news:[email protected]...
> > I got a dewalt biscuit joiner for christmas and I would like to know
which
> > applications would use the #0, #10 and #20 biscuits? Is there a
universal
> > size tat would be for most applications?
> >
> > Thanks in advance
> >
> > keith
> >
> >
>
>
No. Use the largest size you can get away with. They're not that
expensive, so lay in a range.
Cheers
Frank
"Keith Boeheim" <[email protected]> wrote in message
news:[email protected]...
> I got a dewalt biscuit joiner for christmas and I would like to know which
> applications would use the #0, #10 and #20 biscuits? Is there a universal
> size tat would be for most applications?
>
> Thanks in advance
>
> keith
>
>
Keith Boeheim wrote:
>I got a dewalt biscuit joiner for christmas and I would like to know which
>applications would use the #0, #10 and #20 biscuits? Is there a universal
>size tat would be for most applications?
Areas/items requiring the #0 take a number #0.
Same goes for #10 and #20.
OK, all kidding aside, OK, actually that was an answer, I
find that most (all) of the time I use the #20. When a #20
won't fit I use a #10 and when a #10 won't do I use the #0.
And when the #0 won't do I use the #FF (I have a
Porter-Capable).
Let's put it this way. A bottle each of the #0 and #10 will
last as long as ten packs/containers/bottles of the #20.
Your Mileage May Vary.
UA100